Process Hazard Analysis (PHA): A Practical Guide to What OSHA Requires and What Good Looks Like

Empty process hazard analysis meeting room with binders and a blank whiteboard

Process Hazard Analysis (PHA): A Practical Guide to What OSHA Requires and What Good Looks Like

A PHA is the structured study that asks what can go wrong in a process, how bad it could be, and whether the safeguards are enough.

By Timothy Porritt · Porritt Inc. · November 21, 2026

A Process Hazard Analysis is the element of a process safety program where a team sits down with the drawings and works out, systematically, how the process could hurt people. Under OSHA’s Process Safety Management standard, 29 CFR 1910.119, it is mandatory for covered processes, and it is the study most of the other elements depend on.

What the Regulation Requires

Paragraph (e) of the standard requires the employer to identify, evaluate, and control the hazards of the process using a methodology appropriate to its complexity. The PHA must address:

  • The hazards of the process
  • Previous incidents that had the potential for catastrophic consequences
  • Engineering and administrative controls and how they relate to each other
  • The consequences if those controls fail
  • Facility siting
  • Human factors
  • A qualitative evaluation of the range of possible safety and health effects on employees

The study must be performed by a team with engineering and operations expertise, including at least one employee who has experience with the specific process and one member who knows the methodology being used. It must be updated and revalidated at least every five years, and PHAs must be retained for the life of the process.

Accepted Methods

The standard names What-If, Checklist, What-If/Checklist, Hazard and Operability Study (HAZOP), Failure Mode and Effects Analysis, and Fault Tree Analysis, and allows an appropriate equivalent. In refining and chemicals, HAZOP is the default for continuous process units, usually followed by Layer of Protection Analysis on the higher-consequence scenarios. The differences are covered in PHA vs. HAZOP.

What a Good PHA Needs Before It Starts

A PHA is only as good as the process safety information behind it. Before the first session the team needs accurate piping and instrumentation diagrams, relief system design basis, safe operating limits, materials of construction, and cause-and-effect documentation. If the drawings do not match the field, the study analyzes a plant that does not exist.

Recommendations Are the Product

The standard requires a system to promptly address findings and recommendations, resolve them in a timely manner, document the resolution, complete actions as soon as possible, and communicate them to affected employees. In audits, open and overdue PHA recommendations are among the most common findings, and after an incident they are the first thing investigators ask for.

Where PHAs Fall Short

  • Stale process safety information. Revalidations built on drawings that were never updated after changes.
  • Safeguards credited without checking. Alarms with no defined operator response, relief devices never verified against the scenario, interlocks that are bypassed.
  • Superseded standards. Safeguards judged adequate against an edition of a code that has since changed. See What Is RAGAGEP?.
  • Siting and human factors treated as checklists. Both deserve real analysis, particularly for occupied buildings and for procedures that rely on operator action under stress.
  • No consideration of deliberate misuse of the control system. Traditional PHAs assume safeguards fail randomly and independently. That assumption is examined in What Is Cyber-Informed Engineering?.

Why It Matters

The PHA is where an organization decides, on the record, which risks it has accepted and why. Done well, it is the most valuable engineering document a facility owns. For how it fits the rest of the standard, see OSHA PSM Explained.

Related reading


Timothy Porritt is founder of Porritt Inc., building AI-powered tools for process safety, engineering compliance, and industrial operations. Based in Salt Lake City, Utah. Contact: timothy@porrittinc.com.

Scroll to Top